PARAGON Wall

The compact comfort module PARAGON Wall is a constant flow product that in the standard design has a setting knob for easy and fast regulation of a constant air flow from the slot openings.

The PARAGON Wall can also be integrated in the WISE system as a constant flow module with control of water valves.

Comfort module PARAGON Wall with integrated supply air damper in the product is designed for rear-edge mounting in the wall.

The casing is manufactured in galvanized sheet steel (zinc plated) Grill is in prepainted sheet steel RAL 9003, Coil in copper and aluminium.

Standard colour:

• RAL 9003 White (Signal white), gloss ratio 30 ± 6%

Alternative standard colours:

• RAL 7037 Grey (Dusty gray), gloss ratio 30-40%)
• RAL 9010 White (Pure white), gloss ratio 30-40%)
• RAL 9005 Black (Jet black), gloss ratio 30-40%)
• RAL 9006 Silver (White aluminium), gloss ratio 70-80%)
• RAL 9007 Grey (Grey aluminium), gloss ratio 70-80%)
• Other colours available on request

PARAGON Wall is available in three different sizes and two selectable sides for water connection.

The product is also available with different factory mounted accessoreis.

The PARAGON Wall has two holes on each short side for suspension and is mounted with a threaded rod in each hole.

For installation use the assembly fitting containing threaded rods, ceiling brackets and nuts to all four mounting brackets.

Threaded rod length from 200 mm. In the event of large distances between ceiling and unit, double threaded rods with thread locks are used. Assembly fittings SYST MS M8 (Figure 18) are ordered separately.

The work involving the casing can begin once PARAGON Wall has been fully installed. The product is designed to be placed at the rear of the room adjacent to the corridor and installed in the space above the suspended ceiling in the corridor. To simplify the work, cut-out dimensions are given in separate installation instructions at www.swegon.com.